Steel
French doors.
A pair of hinged leaves — dual hinged — in four set designs, from a clean full-glass pair to the classic heritage grid.
The shape,
settled first.
French doors are a pair of hinged leaves that meet in the middle and open the whole width of the frame — the opening people picture first when they picture steel joinery, because the slim meeting stile is where a steel section shows most against aluminium.
Four set designs cover the range: a full-glass pair, a three-lite division, the heritage multi-lite grid, and a kick-plate design for hard-working thresholds. Each is a fixed layout of panes and lockbox; you then choose the suite, colour, hardware and glass.
In W20 the pair reads at its slimmest for internal and heritage work; W40 is the everyday double-glazed choice; W50 TB adds a thermal break for the cold-climate envelope without changing the proportions.
External sizes are governed by wind zone — we confirm limits for your site when you enquire. See how the range performs.
Pick a design.
Then make it yours.
Each design is a fixed layout — panes, lockbox, kick plate. Open one in the builder and it carries straight through: suite, colour, hardware and glass are yours to choose, and nothing you pick here is asked again.
Same design.
Different steel.
The suite is the profile system behind the design — it sets the sightline, the glazing and the warmth. Relative cost shows as a tier, one to seven; a number appears only in the builder, once your opening is fully specified.
W20
The slimmest. Single-glazed.
Heritage, internal partitions, mild climates
Finished
by hand.
Every unit is grit-blasted, primed and top-coated in the colour you choose — our house palette or any RAL on request — with the full corrosion-protection process underneath.
This style usually carries lever hardware — round, square or rectangular rose — in a choice of seven finishes. Glass runs from clear toughened to low-E insulated units, matched to the suite you choose.
Steel Hinged Doors
One leaf, side-hung — the everyday steel doorway, in six set designs from a single full-height lite to a six-lite grid.
Steel Sliding Doors
Top-hung, bottom-guided panels that slide away — two, three or four panels to a run. We choose sliding over bifold for reliability.
Arched Steel Doors
Single or dual hinged doors under a curved head, drawn to your radius — the shape aluminium can’t do.
Build your opening — suite, colour, hardware, glass.
Don’t wait. Plan ahead.
Steel joinery is complicated to make — every joint welded, ground and finished by hand. Bring us in early with your architect and the timeline takes care of itself. Specify it at the start, not the end.